Results 1 to 1 of 1
Thread: Support/Bridging Issues
-
03-06-2017, 11:39 AM #1
- Join Date
- Mar 2017
- Posts
- 1
Support/Bridging Issues
In MakerBot Desktop I was able to print support in appropriate area to prevent sagging. However after upgrading to the Replicator + and having to use MakerBot Print the settings for the supports are not the same and I am unable to print my model without sagging issues regardless of the orientation of the print.
How do I get the same supports from MakerBot Desktop into MakerBot Print? Any suggestions would be greatly appreciated.
MB Desktop pic.jpg MB Desktop Setting.jpgMB Print.jpg
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help