Quote Originally Posted by curious aardvark View Post
You'd need to be using amf files and some kind of specially customised slicer.
I will only play with open source. Custom slicer to me sounds very much like a software that will stop receiving updates at some point. But open source promises I can just go find another software that is properly maintained. Even as businesses and trends rise and fall. We should all be very cautious about setups that run 'custom' firmware or slicers. Typically printers built with this tech resell on ebay for dirt cheap. There is Absolute Beauty and Perfection in Mainstream Open Source. Can it run repetier? Can it run simplify3d? Can it run Prusa Slicer? Can it be run by octoprint/Cura?