Results 1 to 3 of 3
-
03-01-2017, 01:34 PM #1
- Join Date
- Oct 2016
- Posts
- 3
Using left over 3D printer filament in 3D printing pens
At the makerspace I'm a member of, sometimes pieces of 3D printing filament get cut off and discarded usually because something went wrong with the feed mechanism and the toothed wheel ground it down a bit. Could these curved and slightly damaged pieces be used reliably in a 3D printing pen? What 3D printing pen accepts curved pieces of 2.85 mm filament? Thanks.
-
04-19-2017, 04:49 AM #2
- Join Date
- Oct 2016
- Posts
- 3
*bump* 10char
-
04-24-2017, 10:30 AM #3
I am not aware of any 3D pens that use 2.85mm. All the ones I have seen use 1.75mm. Somebody must make one though?
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery