Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 18

Hybrid View

  1. 02-08-2017, 10:11 AM #1
    jfkansas
    jfkansas is offline
    Super Moderator
    Join Date
    Apr 2014
    Location
    KS
    Posts
    907
    Add jfkansas on Thingiverse
    Did you level the bed with it heated to at least 70-80c? There is some metal expansion that happens when heated and it tweaks the level a bit. So if it is level cold, when heated it can throw it off some. When leveling always heat the bed, but leave the extruder cold.
    Reply With Quote Reply With Quote
  2. 02-08-2017, 10:16 AM #2
    JustinDS89
    JustinDS89 is offline
    Student
    Join Date
    Jan 2017
    Posts
    45
    Quote Originally Posted by jfkansas View Post
    Did you level the bed with it heated to at least 70-80c? There is some metal expansion that happens when heated and it tweaks the level a bit. So if it is level cold, when heated it can throw it off some. When leveling always heat the bed, but leave the extruder cold.
    Hello again JFKansas, I did not level the bed with it heated. I will have to try that. I didn't think about that being an issue. Appreciate the feedback.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules