Problem with certain print. Support coming loose.

[JustinDS89]

Right, I even tried using a raft underneath to help them stay, but it messed up in the same place every time. Like I said I got it to finally print though.

[jfkansas]

Right, I even tried using a raft underneath to help them stay, but it messed up in the same place every time. Like I said I got it to finally print though.

Using slurry helps, it acts like a raft or brim if you use it right. Also you don't have to use the default support settings. Running the supports at 2 angles helps with stability, 45 and -45 is pretty good, or 0 and 90. Usually you can go down to 10-15% fill on supports at 2 angles then run 3-4 layers of dense supports at 60-70% fill.