Results 1 to 10 of 101
Thread: Network Printers
Threaded View
-
07-29-2021, 01:45 PM #40
Yes but does anybody know how to set this up? I have the ESP-01 modules. A few of them. And A BTT writer for programming them before installing them on the SKR 1.4 board. But these are different. Aren't they? I can not find any specific instructions on getting this up and going on the BTT octopus which is the same or extremely similar to the new SKR 2. I will keep searching the internet but if anybody here knows how to get this setup I would really love a hand and I have 2 extras I am more than willing to share.
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery