Printing issues - missing powder with large ojects

[Mike Francies]

Hi Rudschul - I assume the layers are solid and because the sintering melts the powder into a smaller volume there is not enough powder in the next layer to fill that volume. I think you are right in thinking you need to increase the lift of the reservoir. I don't know how quickly the Sintratec software development is but it should be relatively easy to equate the lift with the area being sintered, shouldn't it?

I am surprised you are not experiencing warping with that area of solid infill. I am still getting some warping in the front left corner of my build area and I try not to use that part until I find a solution to the uneven heating.

Edit: Just a thought - can you not tilt it at a very small angle, just enough so it does not print the whole surface at any time?