Results 1 to 3 of 3
-
06-04-2017, 04:17 AM #1
- Join Date
- Jun 2017
- Posts
- 2
Wanhao i3 wont stop when my probe is activated (ramps1.4) PLEASE HELP
I'm switching over my wanhao i3 that had a z probe with stock board and marlin to ramps with repetier firmware. It doesnt stop when my zprobe is activated. I use M119 and it shows that my zprobe and my z min(which is my probe in the min pins) is H when not activated and L when activated and i set the firmare to be normally closed. Please help
-
06-04-2017, 01:49 PM #2
If you have Repetier firmware.... You don't have Marlin. If you had Marlin firmware, I could help you.
-
06-10-2017, 04:31 PM #3
- Join Date
- Jun 2017
- Posts
- 2
i was using repetier but i figured it out on marlin, thanks though.
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help