Looking at Pegasus 12

[augerpro]

So a different motor comes with the Titan? It cannot use the stock Nema 17? (is too much torque a problem?) Also weight was mentioned, is this an issue? Is the Titan w/ lower weight motor desirable just because it is lower weight?

BTW thanks both of you for giving me the sort of feedback I need!

[BLKKROW]

So a different motor comes with the Titan? It cannot use the stock Nema 17? (is too much torque a problem?) Also weight was mentioned, is this an issue? Is the Titan w/ lower weight motor desirable just because it is lower weight?

BTW thanks both of you for giving me the sort of feedback I need!

You can certainly use the stock motor to run the Titan, it will just provide a lot of Torque. This isn't an issue at all and will certainly push any filament you feed it. One of the advantages of using a geared extruder is you can use a motor with less weight.

This means your carriage theoretically, can run at a greater speed.

Edit: I think Colin only has one type of motor, so if you purchase it with the Titan you will get the typical motor. Also, take a look at this review:

https://www.youtube.com/watch?v=tiAQ9slUZ58&t=3s