Subscribe to Our Newsletter Advertise
Close



Results 1 to 7 of 7

Hybrid View

  1. 12-10-2016, 01:52 PM #1
    Ward
    Ward is offline
    Technologist Ward's Avatar
    Join Date
    Aug 2015
    Posts
    190
    Quote Originally Posted by noiseboy72 View Post
    I've had this where the extruder stopped heating for a few minutes, causing a gap, then spaghetti!
    In my case, it was a board fault, with a dry joint to the heater socket. Never had this issue again since.
    Can you tell me how you found this fault and how you fixed it?
    Thanks
    Reply With Quote Reply With Quote
  2. 12-16-2016, 05:04 AM #2
    noiseboy72
    noiseboy72 is offline
    Technologist
    Join Date
    Apr 2016
    Posts
    120
    Quote Originally Posted by Ward View Post
    Can you tell me how you found this fault and how you fixed it?
    Thanks
    Yep, took the board out, got the magnifying glass and had a good look around the connector and components. The leg of the connector was slightly corroded and this had prevented a good joint. Applied some heat and fixed the problem.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules