Auto_Bed_Leveling: Z-Probe Repeatability code

[htaxil]

RC-6 is pretty solid. If you are loading up a new printer, it is a good firmware to load.

Hi Roxy,
I took your advice and I realized my new configuration based on RC-6 version.
I have a problem with the bed probing. The G30 command works well, the Effector will stop when the probe touch the bed, but the G29 seems not taking into account the state of the probe as the effector continues down.

For information, i tried to use #define Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN or Z_MIN_PROBE_ENDSTOP instead, and have exactly the same behaviour

Edit :
All right, i found what's wrong : I forgot to uncomment "#define MECHANICAL_PROBE", now everything works perfectly