Auto_Bed_Leveling: Z-Probe Repeatability code

[brainscan]

ahh I wondered if adding #ifdef ENABLE_AUTO_BED_LEVELING at the beginning would help but wasnt really sure if that was missing for some reason or if the #endif somehow got pasted into the end, i'll add both of those back in now. No my probe offset is x 13 y 0 z -7.4 but it shows endstop hit between -0.4 and -0.8

[Roxy]

ahh I wondered if adding #ifdef ENABLE_AUTO_BED_LEVELING at the beginning would help but wasnt really sure if that was missing for some reason or if the #endif somehow got pasted into the end, i'll add both of those back in now. No my probe offset is x 13 y 0 z -7.4 but it shows endstop hit between -0.4 and -0.8

OK... This isn't going to be that hard to figure out! (Famous last words!!!!) Because the Z number should be very close to your Z_PROBE_OFFSET_FROM_EXTRUDER

And yours is 1/10 of it...

1 of 10 z: -0.791797 mean: -0.791797 sigma: 0.000000