Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 12

Hybrid View

  1. 11-28-2016, 09:13 AM #1
    Todd-67
    Todd-67 is offline
    Engineer-in-Training
    Join Date
    Apr 2015
    Location
    Northern Ohio
    Posts
    198
    .2mm nozzle and slow your speed way down. if the part has fine details in the z direction a reduced layer height would be a benefit.

    Your 245 degrees might be ok but it really depends on the filament itself. I am usually down around 230-235 but I print out a temperature test print every time I get a new roll to test what is best.
    Reply With Quote Reply With Quote
  2. 11-28-2016, 04:43 PM #2
    Sabbath
    Sabbath is offline
    Student
    Join Date
    Oct 2016
    Posts
    19
    Quote Originally Posted by Todd-67 View Post
    Your 245 degrees might be ok but it really depends on the filament itself. I am usually down around 230-235 but I print out a temperature test print every time I get a new roll to test what is best.
    Can you explain this process a little further? What indicates the temperature is too high or low?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules