...AND YES... I AM BACK AGAIN...

The GERMAN REPRAP, is still NOT functioning...
Well after a very short break of NOT working... GERMAN REPRAP CRAP actually , managed to make it print 2 parts... The one was the ready part of the SD card if memory serves right and the other was one of my parts...

I can say to be honest the quality was acceptable BUT on the other hand I have changed and upgrade almost everything...

ANYWAY THE GERMAN REPRAP CRAP IS REFUSING TO WORK..

Actually the Z- axis is not moving when in gcode... Everything works the X-axis , Y-axis , E-axis but the Z-axis is not moving at all just a very rough noise from NEMA motor... BUT WHEN IN REPETIER MANUAL MODE... The Z- axis works perfectly...

I have to change the .ino file with my own settings...