Oops. I think you call this a fail.

MakerwareFail.jpg

Using makerware, it seems to tangle the nozzle in the last layer and rips it up. The first two tried weren't this interesting. "I believe you are trying to invent a new art form?" Perhaps it's because today is the 9th?

First attempt with makerware this morning it stopped extruding, but didn't rip it off the build plate. I notice makerware sets the temperature to 230. ReplicatG used 220.

I saw the hood mentioned some where, I think in this thread even. How do you keep the warm air from escaping out the open top of the unit where all the guide tubes and wired go?