Results 1 to 10 of 50
Thread: Another Sintratec kit built
Threaded View
-
11-16-2016, 01:40 AM #22
- Join Date
- Jan 2016
- Posts
- 41
yes, Sintratec try to help where they can do.
@fred_dot_u: You will not need to fill the chamber completly. For calibration i think about 3 cm powder will be enough. At the beginning you will have to calibrate your temperature. If you have a lot of warping mostly your print will go autamaticly into trash. :-)
Keep aware the the glass is clean and is not between your IR sensor. If this happens your temperature will not be correct.
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help