Results 1 to 10 of 40
Hybrid View
-
10-27-2016, 12:05 PM #1
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
-
10-27-2016, 07:46 PM #2
- Join Date
- Oct 2016
- Posts
- 11
That what a slicer is for. With Simplify 3D, you can define set layer thickness at different heights. I know you are talking about changes within a layer, but I don't see how that can be accomplished without the slicer telling the controller where to change the height at a specific point.
I would not trust an instrument like this to establish your z height and use it as a feedback loop for now. If you calibrated your steps per mm accurately, there is no reason to do what you are saying unless you are skipping steps. A servo motor control would be a better option. I am not sure if most firmware even have the ability to use a closed feedback to adjust heights. I mainly use reprap and I don't believe it has the ability, but I may be wrong.Last edited by ShadowX; 10-27-2016 at 07:51 PM.
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery