Quote Originally Posted by curious aardvark View Post
could anything else be adding extra vibration ?
noisy cooling fan for example ?
Also clean ALL the rods. Not just the z-screw itself but the guide rods as well.
basically when I do a clean (one is due) I wipe down every guide rod and the screw.
You can actually hear the difference in the sound the printer makes afterwards.

Your settings look fine, what make is the pla ? And is this the same roll that worked fine before the problem started ?
Not that I know of. There is an extra cooling fan I have but It was there and on before this started giving me issues so I doubt its that.

Yes I cleaned and oiled all the rods.

Speaking with the manufacturer hes telling me to check the bed screws and the screws holding the z motor. Checked all screws and all were tight, although I was able to tighten the zmotor screws a couple more turns.

Told him that and hes saying he thinks its still a loose screw somewhere. Idk what else to check.