Fully printed UAV/FPV plane

[CaptainObvious]

That is too cool! Be sure to make a very good parts list so anybody (like me) can make it! Was that landing too rough for it? Did it break anything coming down the first time?

I compiled the list of materials for the plane, I got everything from HobbyKing.com, but the list can be used as a reference to get equivalent parts from other stores:

-Elevon servos: Turnigy TSS-10HM Digital Micro Servo X2
-Flaperon servos: D05010MG 5.7g / .61kg / .07sec Digital Metal Gear Micro Servo X2
-Motor: hexTronik 24gram Brushless Outrunner 1300kv
-ESC: Turnigy AE-25A Brushless ESC
-R/C receiver: OrangeRx Open LRS 433MHz 9Ch Receiver
-Elevon servo pushrod link: Ball and roller link 4.8x2x18mm (10pcs/set) & Threaded Ends M2xL20mm
-Flaperon clevis: Nylon Snap-Click style clevis for 1mm rod
-8x4 propeller (PRODUCT ID: H8011A )
-M3 nylon screws and nuts.
-3mm outer diameter nylon pushrods.
-1mm steel wire for elevon and flaperon linkages.
-8mm and 3mm diamter carbon fiber tube for wing and tail spars, 1,5mm diamter carbon fiber rod for control surface hinges.
-Glass Fiber Cloth 450x1000mm 48g/m2 to reinforce the inside of the fuselage nose section.