Results 1 to 7 of 7
Thread: ABL Servo probe issues
Threaded View
-
10-08-2016, 09:48 AM #6
- Join Date
- Feb 2015
- Posts
- 371
This is getting ridiculous! So yesterday after all that I had a good print. Now, this morning I went to print and the servo is now over extending! I opened pronterface and issues some m401 and m402 commands to confirm the angles are wonky. first extend was too far. I retracted and then issues a m280 p0 s145 to check. I then did some m401 and 402 commands and it is now working. Weird? Does a m280 reset the angle in the firmware? I did try to enable the eeprom to see if that helped/hurt.
is this a servo issue?Last edited by tsteever; 10-08-2016 at 10:31 AM.
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help