Subscribe to Our Newsletter Advertise
Close



Results 1 to 7 of 7

Hybrid View

  1. 10-08-2016, 09:48 AM #1
    tsteever
    tsteever is offline
    Engineer-in-Training
    Join Date
    Feb 2015
    Posts
    371
    This is getting ridiculous! So yesterday after all that I had a good print. Now, this morning I went to print and the servo is now over extending! I opened pronterface and issues some m401 and m402 commands to confirm the angles are wonky. first extend was too far. I retracted and then issues a m280 p0 s145 to check. I then did some m401 and 402 commands and it is now working. Weird? Does a m280 reset the angle in the firmware? I did try to enable the eeprom to see if that helped/hurt.

    is this a servo issue?
    Last edited by tsteever; 10-08-2016 at 10:31 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules