Quote Originally Posted by TheGhzGuy View Post
Hello all!
I just ordered my first 3D printer yesterday, the Original Prusa i3 MK2, fully assembled version. I know the single roll of filament won't last long, nor will it fulfill that many uses very well, so I came here to ask if there was anything this forum recommended. .......l.
Hi

What part of the world are you in?

A filament source that makes sense in Australia may not make sense in the US. One that works fine in the US may be nonsense when shipped to Europe.

The printer you are getting should print PLA, ABS, and PETG just fine. I print all three on a similar machine with very little trouble. Find a brand that makes sense for you and get a couple spools. Play with it on the printer until you get it dialed in for your setup. You will learn a lot about the printer as you go along. You may need to re-visit settings a couple of times as you figure stuff out.

Bob