Results 1 to 10 of 16
Thread: QIDI 1 surging fan
Threaded View
-
09-29-2016, 08:25 PM #12
The fan that is the blower on the nozzles will vary in speed. S3D does allow that. it is not either on or off only as far as I have been able to see. I used PLA/PHA just last night to build the adjustable platform jack model and had the fan at 20% for the first 4 layers and at 100% for the rest. The fan did spin at a slower speed during the first four layers. Why?? I am not sure as it is not a 3 pin fan power connection that usually controls fans. I have not disassembled the unit to check the board but the control board may very well control the fan speed by adjusting the amount of power it sends to it. I will take it apart in the coming weeks and find out.
As far as being upset by your rude reply yes I was.
Editor in Chief
Bitsonline
Tips Appreciated But Not Expected
BTC: 16wxHvKd3oU6SVjv6FrenqhkvRmc8t7sPy
DASH: XqyaWxH896j9YeV1M35Gzb5gmRPmPbNDGq
Please explain to me how to...
Yesterday, 02:43 PM in 3D Printer Parts, Filament & Materials