Results 1 to 10 of 93
Threaded View
-
04-05-2014, 08:42 PM #11
I see, it's a lamp. No wonder I couldn't find it when I searched vases... Thanks.
First print was rough and separating. When I lifted it off of the glass it unzipped the bottom layer like spooling line out of a box. I'm printing again at higher temp (245C) instead of (230C) to see if the layers stick better. I think I jumped to fast on the temp as it looks globby. I think I'll knock the temp back to 240C. I need to fine tune my retraction too. That's off. But, all in all, it's going OK. I just need to tweak. This stuff has no odor at all. I think I'm going to like it.Bambu P1S/AMS
NVision4D http://nvision4d.com
Please explain to me how to...
Yesterday, 02:43 PM in 3D Printer Parts, Filament & Materials