What (Non-Branded) 3D Printer Would You Want?

[Roxy]

What ever you do, make sure you can run Marlin on it!

I think the best printer for the money right now is the FolgerTech-i3-2020. It comes as a kit, but that really is a good thing because you know everything about your printer when small problems show up.

You can take a look at it here: https://folgertech.com/collections/3...3d-printer-kit

The all aluminum frame really is nice. Everything starts off square and stays that way, even if you put your printer into the car and bring it to different places. The only suggestion I would have is spend an extra $5 and get an extra 3' section of the aluminum frame. That is really nice to have because the whole purpose of a RepRap printer is so you can make changes and evolve it. Check out: https://folgertech.com/collections/f...l-diy-projects

I'm impressed enough with the printer, I'm doing the UBL (Unified Bed Leveling) software development on it. (The code is up and running at GitHub. But Delta's are not supported yet.) If you order the 20x4 LCD Panel (for under $10.00) you will be able to load that code and run it with no setup effort: https://folgertech.com/products/repr...a-3d-printer-1