10" Pegasus extruder issues....

[uncle_bob]

If you had the E steps at 800, you either loaded the firmware wrong or had something really weird in the eeprom. Either way, check the rest of your settings. It's rare than *only* one of them gets messed up.

Bob

[DrMacZed]

Well there was a small peice of paper in with one of the boxes of parts that had E-Steps 814.xxx so I foolishly assumed that that was the proper setting for the extruder. Now i need to get less scared of mucking about in firmware to get the 100 to stick as it resets to 814 when ever the printer is reset or power cycled.