Results 1 to 10 of 50
Thread: The curse of ABS (Warping)
Threaded View
-
04-12-2014, 07:30 AM #39
Thanks to all of you for these contributions., just a few questions.
@RP Iron Man : nice trick with the garbage bag, how hot does it reach inside ? Don't you fear to overheat some components ? Or do you make holes to keep warm but not too hot ?
I was looking at the Printrbot Go v2 and they wrote on their twitter page they wound't do a heated bed due to warping. So I guess from what you all put this is mainly due to the very "open architecture" and could be solved with closing it a bit, that so ?
Anyone using a Creatr Xl or such big volume machine ? Do they have the same issue ?
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help