Imo Cura lacks parameters/settings, after that its awsome!

Also about the Skirt ye that seems like a great idea, But i just aint sure if it will work,
I might make a aluminium case, Its just i dont have the place for it atm, will think about it i guess :P

Thanks for the help guys ^^

Kinda went back to PLA at the moment for a larger piece, but ye ABS is great for smaller stuff, PLA is very brittle with small diameters/sizes, i guess ABS might do better with that.


/edit
Didnt see your comment yet MeoWorks,
Well i use ABS glue (acetone + abs) and it kinda reacts as a Brim,
I could perhaps use a combination of ABS glue and a Brim, But the problem is then, that the plastic layers will actualy rip,

https://www.dropbox.com/s/cb8kyte9nr...2014.11.08.jpg
That was my last attempt on a larger piece :P 120x50x60 if i remember the size well.