The curse of ABS (Warping)

[ciutateivissa]

Over a couple of weeks I found out that prtinting in ABS is quite tricky for me and I never had perfect results so far. Happy to hear about all your experiences here, but I´m asking myself what would be a real guideline of dos and don´ts? for instance in terms of bed temperature we have quite different results here...

Let´s try to summerize this thread:

- heat bed temperture between 105 - 120 degrees, after first layer reduced to 80 - 100 degrees
- print on Kapton, PET tape, aluminium, glass or mirror - so it don`t matter?
- prepare the bed with glue, ABS paste, glue stick
- use more infill
- constant high ambient temperature or better: heated chamber
- no fan´s at all, problematic if your hotend needs one

Did I missed anything?