gcode for quieter printing

[Nargg]

Hi all!

A while back I ran across some gcode on another forum that adjusted the torque used for the stepper motors during printing. The result was it made the printing a tad quieter. I've lost that gcode. Would anyone here know what the code was or know where the original post was that talked about making the stepper motors a bit more quiet? I just recall it was a single line put into the pre-printing setup of the gcode. I've found stuff on adjusting voltage to achieve this, but I recall at least that it wasn't voltage in this case, more like it was torque settings or similar. It might also be something about "vrefs" but I don't know the code to change those.

Thanks!