Results 1 to 9 of 9
Threaded View
-
07-21-2016, 02:57 AM #1
- Join Date
- Jun 2016
- Posts
- 6
Extruder Gear Skipping filament (0.2 mm nozzle)
So I recently decided to try to print with a smaller nozzle diameter but I have run into a problem.
The filament extrudes somewhat out of the nozzle but after each extrusion step, there is a small thud sound and the filament looks as if it is being retracted.
I believe this is caused due to too much pressure building up in the extruder throat.
I have not had this problem with a 0.4 mm nozzle.
What could be the problem?
Are there any specific settings that must be changed to make it work?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help