Results 1 to 4 of 4
Thread: ABS Layers Not Sticking
Threaded View
-
07-19-2016, 02:24 PM #4
- Join Date
- Jul 2016
- Posts
- 2
The defaults were (in replicatorG):
infill: 10%
layer height: 0.27mm
shells: 1
feedrate: 35mm/s
travel federate: 25
print temperature:220
Yesterday I got a mildly successful print, there was warping but it wasn't as severe as the previous day. Today I tried printing the same thing and the warping was so bad the print came off the raft. There was a noticeable change in room temperature from yesterday to today (today was much cooler). I have no idea if temperature would have that much of an affect, but that is the only change I noticed.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials