Results 91 to 100 of 107
Hybrid View
-
12-07-2015, 04:10 PM #1
- Join Date
- Nov 2015
- Posts
- 7
-
02-13-2016, 02:37 PM #2
- Join Date
- Jun 2015
- Posts
- 1
FFCP Noob here...is the FFCP 2015 version/model affected as well by the dragging problem? I printed a large bathtub model a week ago and it came out pretty ok me thinks:
WP_20160207_19_00_57_Pro.jpg
-
02-23-2016, 07:14 AM #3
Any info about how to troubleshoot the head height difference with the new FFCP?
-
02-23-2016, 07:41 PM #4
- Join Date
- Feb 2015
- Posts
- 91
For the last little adjustment, it is waaay easier to use a shim between the cooling bar and the carriage than to mess with the set screw and the heatbreak tube.
-
02-26-2016, 03:35 AM #5
- Join Date
- Aug 2015
- Posts
- 21
-
02-27-2016, 12:53 AM #6
- Join Date
- Feb 2015
- Posts
- 91
Rich Webb posted a pretty diagram here: https://groups.google.com/d/msg/flas...4/c9IABy6eBQAJ
However, when you get there be sure to expand the message, Google hid the image below the fold. You do this my clicking on the little dashed message below his post.
-
02-27-2016, 12:55 AM #7
- Join Date
- Feb 2015
- Posts
- 91
By the way, I prefer to use thick silicon baking mat cut down to fit. I put one on both sides so I can adjust the height by compressing the silicon more or less by tightening the bolts.
-
06-01-2016, 01:25 PM #8
- Join Date
- Jun 2016
- Posts
- 1
You mentioned you want them slightly different heights, is there a specific one you want to be higher than the other?
Currently I'm printing with my right extruder (Which according to the FF instructions is the one you're meant to use when levelling the bed) but the left nozzle is definitely is very VERY slightly lower and keeps catching my prints. Only very lightly, but it's enough to pull the odd bit off the bed if it's not stuck down well.
Is this that the nozzle is out of whack or my levels or my settings, or just that my adhesion isn't good enough?
-
01-23-2023, 04:34 AM #9
- Join Date
- Nov 2022
- Posts
- 18
Also, you can go to File/Preferences and set the preferred extruder to Left so it will always default to the Left extruder.
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials