Results 1 to 10 of 107
Hybrid View
-
04-15-2014, 09:17 PM #1
- Join Date
- Apr 2014
- Posts
- 5
Great news gentlemen! - this adjustment screw is now on the back (my machine a few weeks old)
which makes it much easier to get to - NOT!
which means you get to do something like this
my notes -
The fan screws hold the stepper motors on.
I think it would have been easier had i unloaded the filament first.
you can put the fan screws into the mounting holes on the bottom of the plate, and mine were spot on the same length - if only i had something the right height to check it against... i did think about printing one... and then was like.. oh yeah.. pieces..
It's hard to measure with calipers - as there are no good parallel surfaces to the nozzles - but i think i did ok.
-
01-02-2023, 09:11 AM #2
- Join Date
- Jan 2023
- Posts
- 2
DSCN7257.jpgDSCN7253.jpgJust so you know the turbofan duct is trash. I found a way to fix this on Thingiverse. (I didn't make it) (Please excuse my terrible picture quality)
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery