Flashforge Creator Dual / Pro How to fix Dual Extruders dragging across prints.

[SL666]

Great news gentlemen! - this adjustment screw is now on the back (my machine a few weeks old)

which makes it much easier to get to - NOT!



which means you get to do something like this



my notes -

The fan screws hold the stepper motors on.

I think it would have been easier had i unloaded the filament first.

you can put the fan screws into the mounting holes on the bottom of the plate, and mine were spot on the same length - if only i had something the right height to check it against... i did think about printing one... and then was like.. oh yeah.. pieces..

It's hard to measure with calipers - as there are no good parallel surfaces to the nozzles - but i think i did ok.

[why am i here]

DSCN7257.jpgDSCN7253.jpgJust so you know the turbofan duct is trash. I found a way to fix this on Thingiverse. (I didn't make it) (Please excuse my terrible picture quality)