MakerFarm 8" Prusa i3v Enclosure

[SgtToe]

You can always do this and put an octoprint/raspberry pi webcam in there to view the printing online. Also it would cost about the same as a plexiglass sheet to buy all the stuff needed for an octoprint setup

Yep! I have a pi from an old project, a web cam that is compatible, and the wifi dongle and just downloaded the distro for for octoprint. Just need a powered hub and I will have octoprint before I have a printer, lol.

[AbuMaia]

Also it would cost about the same as a plexiglass sheet to buy all the stuff needed for an octoprint setup

I didn't know plexi was that cheap.

[sniffle]

I didn't know plexi was that cheap.

24x48 sheet of 1/4"plexi at lowes is 58$ i looked yesterday

[gmay3]

I didn't know plexi was that cheap.

Ha! Yeah maybe 2 octopi setups!

I'm going to be using 8mm thick glass I'm re-purposing from a broken digital bathroom scale as my "view port". I'm going to frame it with wood and use that as the door. I was going to use plexi but to me it just doesn't make sense to spend that much on a door.