MakerFarm 8" Prusa i3v Enclosure

[gmay3]

It's good to hear that there haven't been many warping issues!

I'm working on the 3D model now of the enclosure now, about 50% done. Look for a finished model to critique on Friday!

So far I'm planning to have the power supply external but it's good that you mention putting the RAMPS board external as well. I think that's a good idea.

I want to put the LCD outside so moving the RAMPS board outside would actually solve a lot of my design problems! Now I wont need a ribbon cable extension. Thanks bteeter!

As far as extreme heat goes, I'm planning on having active cooling with a very slight airflow running through the front or sides of the case and exiting the case through the back side corner and then out through an exhaust vent from my clothes dryer. I'm hoping it wouldn't get too hot in there but it will definitely be hotter than room temperature.