Quote Originally Posted by Builder1 View Post
Just did a test on glow paper testing out:
1) Why was it small?
2) Where's my freakin' rafting!

1) As for the size... I still have no clue why this happened. It was "actually" only about 20% smaller than it was suppose to be.
My test on glow paper printed at the exact size it was suppose to be.
Gotta remember that you are projecting in a cone, so the higher the resin starts, the higher you are on that cone, and thus the print will be smaller in the X/Y ranges, but not in the Z...
It'll probably be resolved by making sure the software is set correctly for that height, so it can compensate...