Results 1 to 10 of 17
Hybrid View
-
07-03-2016, 09:31 AM #1
- Join Date
- Jul 2016
- Location
- Windsor, ON
- Posts
- 4
Printing my first test print on mine right now lol
It was pretty easy to get setup and printing, it's packed a little awkward in the box and I had to losen off the front lower cross brace to get the bed frame to slide in, otherwise I had it up and printing one of the sample prints from the SD card in maybe half an hour?
I think I got lucky that everything is square and got the bed leveled on the first try.
Milton is right though, the sample is printing really slowly, been going for a little over an hour now and the display says it's only at 53%, too lazy to pull out the DSLR to get better pics, but I'm impressed so far.
-
07-03-2016, 10:17 AM #2
- Join Date
- Jul 2016
- Location
- Windsor, ON
- Posts
- 4
And 2 hours later it's done!
VERY impressed for a first print out the box without any tweaking.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion