Quote Originally Posted by dustmann View Post
Did you define the number of servos? define the z endstop as a servo? Define the servo endstop angles?
Thanks Dustin,

Yes I did define the number of servos to 1, pretty sure I defined the z endstop as a servo, and yes I set the angles. Someone did point out to me today one possible issue is that I am not 100% that I tried to run the G29 right after I did a G28. And then I was told the G29 apparently WILL NOT run unless if ran immediately after a G28. So I will test that.

Otherwise yes I did download the RC6+bugfix and was trying to again port all the settings and give it a go. And let everyone know by Friday where I am at with this then.

Thanks for the link to your settings, it will come in handy as I do own all the parts for the itty bitty flex v2.1, I just need to print the parts. And I was trying to get just a basic auto bed level setup before I printed two sets of the itty bitty parts and get building.

James