Results 1 to 2 of 2
Thread: top of model not closing up
Threaded View
-
03-11-2014, 04:34 PM #2
- Join Date
- Jan 2014
- Posts
- 462
I can see holes in the back lower down as well. Either you are under-extruding or your bridging is not the best. First step is to follow the calibration guide on the reprap wiki - especially section 3.9. This will help you with your bridging. If you're still experiencing problems after calibration, try increasing your infill further.
Please explain to me how to...
Yesterday, 10:55 PM in 3D Printer Parts, Filament & Materials