Results 1 to 4 of 4
Thread: where to adjust x-axis?
Threaded View
-
05-11-2016, 08:56 AM #1
- Join Date
- Aug 2015
- Posts
- 31
where to adjust x-axis?
sorry for the stupid question.
but on my FFCP if i design something that takes up the whole bed, when it prints, i can tell it's shifted a little to the left.
the reason is
if i leave 1-2 mm of boarder, it prints right on top of the left edge of the glass, but not on the right.
so i think the x-axis is shifted to the left.
do i adjust this in the FFCP firmware settings? or in simplify 3d settings? (or both?)
thanks
Please explain to me how to...
Yesterday, 02:43 PM in 3D Printer Parts, Filament & Materials