Very nice work! How thick are the gears? Here is a overhead picture of what I want done that kind of shows you how thin I need the gears. Do you think your gears are thin enough to fit on the shafts? Mainly the tire shaft. That is the thinner one. It is a little fuzzy to see.

mm2.jpg

If you can, could you measure the distance from each hole of the gears when they are mesh together to see if it is close to the same distance of my shafts? The picture above also shows the distance between each shaft.

Now I am starting to wounder how much this is going to cost to get these gears ship to me over seas or are you just going to have me pay you for the design work to have some one here in the usa print them out?

Thanks,
Tony