Results 1 to 4 of 4
Threaded View
-
04-30-2016, 01:21 PM #2
Print temp is very high. Speed is also quite fast.
That could be it right there.
Try 235 at 60mm/s
In fact you've got your travel and print speeds the wrong way round.
Travel speeds are usuallt faster than print speeds. I tend to keep them the same to cut down on filament spikes where it's pulled by the suddenlt accelerating print head.
Never seen travel slower than printspeed before.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion