Results 1 to 7 of 7
Thread: Printing troubles with FilaFlex
Threaded View
-
04-28-2016, 03:44 PM #3
Its difficult to know what the issue could be. You may have tried this but I would recommend:
Slowing your print speed down (perhaps significantly from your description) and increase print flow (AKA extrusion rate)
Also flexible filament usually benefits from a high layer height (0.2-0.3mm)
Just some ideas. I hope they help
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion