Switched to Sailfish, but head is printing off the bed, not in middle.

[EagleSeven]

Why do you keep doing that. The guy wants input from real world experience, not from some third party "read it on the web so it must be true".

As I said, it is 'My conclusion' !
Therefore it is 'True to Me' !

Why do You Keep being So Negative about my helpful comments ??
There's No need for you to be So Competitive !

[Mjolinor]

As I said, it is 'My conclusion' !
Therefore it is 'True to Me' !

Why do You Keep being So Negative about my helpful comments ??

Because they are not helpful. I have yet to see a helpful comment from you. If someone tries something and thinks it is crap they post on the Internet about how crap it is. If someone tries something and it does exactly what they need then they do not post about it generally.

The guy has put Sailfish on, a good move. How helpful do you think it is to tell him that he has done something he shouldn't have because you read on the Internet that someone doesn't like Sailfish. What he needs is a solution to his home/centre/off table printing problem not some imaginary diatribe about how you read something google said.

Sailfish is without doubt the best OS for this type of printer, it leaves any of the originals for dead but there is a potential problem with it when installing it if you do not erase your EPROM before you start. This information is given all over the net. If you follow the instructions carefully then you never meet the problem, I didn't because I read everything I could before I made the decision to upgrade

[EagleSeven]

The Fact remains that Sailfish firmware is NOT Needed,
with the CTC printer !
And I want Everyone to Know That to be a TRUE statement !

As a warning to anyone else that may think they should make the Same Mistake that many Others have !
I consider that Very Helpful advice !

[Mjolinor]

The Fact remains that Sailfish firmware is NOT Needed,
with the CTC printer !
And I want Everyone to Know That to be a TRUE statement !

As a warning to anyone else that may think they should make the Same Mistake that many Others have !

What you say is correct but Sailfish firmware will improve all this type of printer so if your intention is to make the most of what you have then Sailfish is the way to go.

If you are content with it not working quite as well as it could do and not printing quite as well as it could then you are right, there is no need to put Sailfish on.