Results 1 to 6 of 6
Thread: Getting the prusa I3 on track
Threaded View
-
05-06-2016, 03:20 AM #6
- Join Date
- Mar 2016
- Location
- Nantes, France
- Posts
- 5
It appears I solved all the problems... hurray!
4: Why the firmware installation is freezing and how to properly install my "P802NV20.hex" one?
-> The problem is a compatibility with my computer. So I used another one and everything went fine... As I won't update the printer every day, I considered the problem solved.FIXED
6.4: Why have I the "avrdude stk500_getsync() not in sync" error and how do I reach the board?
-> see point 4 FIXED
7: Why is it possible to reach the printer using repetier host/server and impossible with cmd/arduino IDE?
-> see point 4 FIXED
But other ones appeared... the lack of rigidity of the overall assembly gives a big load to the motors of the Z-axis. So it was tweaks and tweaks... I am not fully satisfied but it is working so far. And also the metal bed is a pain in the a**! Not sticky without blue tape, too much with blue tape...
ABS Sticking to Build Plate
10-20-2024, 05:02 PM in 3D Printer Parts, Filament & Materials