Results 1 to 3 of 3
Thread: print doesn't separate from base
Threaded View
-
03-07-2016, 04:48 AM #3
There is no heat bed on a M3D, I think.
Have you enclosed your printer ? I think it would be quite easy given its design. I'm not an ABS specialist, but it would perhaps allow you to print at lower temps. This seems hot. I also think that printing that hot WILL cause issues on that printer : it was not designed for that kind of continuous temps.
Have you tried printing without a raft or using PLA or PET instead ?
Please explain to me how to...
Today, 12:15 PM in 3D Printer Parts, Filament & Materials