Quote Originally Posted by Donziboy2 View Post
Check your current limit on your stepper driver. If its to low it wont be able to move. Also when you start making your own slicer configs be careful not to set the stepper speed to high for extrusion or it will do a similar thing.

Here is my setup, still need to finish wire management and do inlet/outlet+filter.

I did check the stepper drivers and the one for the extruder was set to .647v (all the stepper drivers were at this high level) and I reduced it to .391v as per the troubleshooting pdf from Makerfarm but that made no difference.

Your enclosure is pretty damn cool... is that plexiglass?