Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 125

Hybrid View

  1. 03-30-2016, 02:44 PM #1
    Donziboy2
    Donziboy2 is offline
    Student
    Join Date
    Jan 2016
    Posts
    34
    Quote Originally Posted by printbus View Post
    But just to clarify, the printer prevents cold extrusion, not Pronterface or other host software. Either the printer firmware has things set to allow cold extrusion, or the printer is receiving an M302 gcode command to enable it. IMO, allowing cold extrusion by default isn't a good idea.
    We are talking about the manual controls. If your trying to extrude with a cold hotend with everything assembled then you deserve to have to clean up a mess.
    Reply With Quote Reply With Quote
  2. 03-30-2016, 02:51 PM #2
    printbus
    printbus is offline
    Staff Engineer printbus's Avatar
    Join Date
    May 2014
    Location
    Highlands Ranch, Colorado USA
    Posts
    1,437
    Add printbus on Thingiverse
    Quote Originally Posted by Donziboy2 View Post
    We are talking about the manual controls...
    Doesn't matter. The printer still shouldn't typically be allowing it. Who knows - maybe pronterface IS sending an M302 when you manipulate the manual controls.
    Reply With Quote Reply With Quote
  3. 03-30-2016, 02:57 PM #3
    Donziboy2
    Donziboy2 is offline
    Student
    Join Date
    Jan 2016
    Posts
    34
    Quote Originally Posted by printbus View Post
    Doesn't matter. The printer still shouldn't typically be allowing it. Who knows - maybe pronterface IS sending an M302 when you manipulate the manual controls.
    It shows the output I can look when I get home.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules